Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Setting Oven Controls (cont'd)
Adjusting Your Oven Temperature
Your new oven has been factory calibrated and tested to ensure an accurate baking temperature. for the first few
uses, follow your recipe times and temperature recommendations carefully. If you feel your oven is too hot or too
cool from your baking experience, the oven temperature may be adjusted to your liking, see instructions below.
Note: DO NOT adjust your oven temperature based on oven thermometers, such as those found in grocery stores
because they may not be accurate.
To Adjust the Oven Temperature (do not use Bake or Broil while adjusting the oven temperature):
Bake
1. Press & hold the
Note: If the oven temperature has been previously adjusted from the factory setting, the current temperature
adjusted value will appear in the display instead.
2. You may increase the oven temperature in 5°F increments with each press of the
oven adjustment of +35°F. You may also adjust the oven temperature downward in 5°F increments with each
press of the
key pad ( total range of -35 to +35 ). Note: Your oven control was factory set in the (Fahrenheit)
°F Temperature Display Mode. To change for (Celsius) °C, see Changing the Temperature Display Mode in the
Oven Control Functions section of this Use & Care Manual.
3. If no other key pad is pressed after 5 seconds the display will begin to flash.
4. If you do not want to keep the display adjustment, press the
will cancel the temperature adjustment procedure. To start this procedure over again begin with step 1 above
OR;
5. If you want to keep the adjustment, wait until the display quits flashing and the oven control beeps once.
6. The oven temperature adjustment has be accepted by the oven control and the display will return to the time of
day.
Notes: The oven temperature adjustment may be made if your oven control has been set to operate in the (Celsius)
°C Temperature Display Mode. In this case each press of the
(maximum +18°C) or downward (maximum -18°C), depending on which arrow key pad is pressed.
Failure Modes
All failure modes give a visual and audible alarm. When display shows F10 (internal fault), F30-F31 (oven sensor
circuit fault) or any other F error codes, the electronic oven control has detected a fault condition. Note that code
STOP
Clear
and push the
pad to clean the display and stop the beeping. reprogram the oven. If fault recurs, push
pad, disconnect the appliance to prevent damage and contact an
key pad and release after the display shows the factory temperature setting of 00.
STOP
Clear
key pad before the oven control beeps. This
or
key will adjust in 1°C increments upward
authorized servicer.
12
key pad to a maximum
STOP
Clear
Capítulos
Tabla de contenido
