Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3.0 Prepare Cable:
3.1
For 1000 volt maximum: Thoroughly scrape all wax
and dirt 5" back from each cable end. Prepare cable
ends exactly as shown. See Figure 1.
3.2
For 5 kV maximum: Thoroughly scrape all wax and
dirt 5" back from each cable end. Prepare cable ends
exactly as shown. Do not cut insulation while
removing outer sheath. See Figure 2.
Bare Conductor (1 1/4" maximum) ................A
Insulation Pencil (1/2") ....................................B
Sheath Opening (4 3/4" maximum) ................C
4.0 Make Connection
4.1
Make connection according to connector manufacturer's instructions. Connectors with a smooth
conforming shape are recommended. Bulky, angular types should be avoided. The mold will accept:
•
Split Solder Sleeve
•
C-Type Compression Connectors up to #2 AWG
•
Split Bolt Connectors up to #4 AWG
4.2
Multi-conductor Cables. Stagger individual connectors (provide lateral spacing of 1/2" between ends of
connectors) and insulate connector with Scotch™ 23 Electrical Tape. Sheath opening should not exceed
4 3/4". Use 3M™ Scotchlok™ or indent type connectors.
1 1/4"
(max)
1 1/4" (max)
1000 Volt maximum
1/2"
1/2"
1 1/4"
max.
A
B
B
4 3/4" (max)
C
5 kV maximum
Figure 1
Figure 2
Tabla de contenido
