3M Scotchcast 82-A Instrucciones

Scotchcast
Splice Kit 82-A
Instructions
1.0 Applications
Designed for use in weather-exposed or direct-burial locations. For making inline (straight) splices on unshielded,
synthetic insulated cables rated up to a maximum of 5kV and for multiple conductor cables rated up to a maximum
of 1kV. UL Listed for direct burial and submerged applications up to 600 volts and 90°C. For use with UL Listed
connectors only. These kits will accommodate the following connectors and conductor sizes:
Kit No. Conductor Size
82-A #10 AWG (min.)
#2 AWG (max.)
2.0 Kit Contents
Mold Body.......................................... A
End Caps............................................. B
Abrasive Strip ..................................... C
3M ™ Scotchcast ™
3.0 Prepare Cable
3.1 For 1000 volt: Thoroughly scrape all wax
and dirt 5" back from each cable end.
Prepare cable ends exactly as shown. See
Table A for proper sizing and dimensions.
Sheath Cutback ...................A
CAUTION
Working around energized electrical systems may cause serious injury
or death. Installation should be performed by personnel familiar with
good safety practice in handling electrical equipment. De-energize and
ground all electrical systems before installing product.
Power Cable
™
Connector O.D.
13/32" (maximum)
Resin 4 .................. D
Wire connector system for use with underground conductors.
Cable O.D. Sheath Opening (L)
3/4" (max.) 4 1/2" (maximum)
B
LISTED 98U1
(A)
1/2
connector length
A
D
A
A
1000 Volt maximum
(B)
1/4"
B
C