HAMPTON BAY 91371 Guía De Uso Y Mantenimiento página 8

Assembly - Close-To-Ceiling Mounting
1
Preparation for close to ceiling
mounting
□
Remove the canopy ring (JJ) from the canopy (C) by turning
the ring counter-clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (HH) located in the "L
shaped slots".
□
Remove and save the two canopy screws (II) in the round
holes. This will enable you to remove the mounting bracket (A).
□
Remove the decorative canopy bottom cover (KK) from the
canopy (C) by depressing the three studs.
HH
2
Routing the wires
□
Remove three of the six screws and lock washers (LL)
(every other one) securing the motor collar (P) to the top of
the fan motor housing (D).
□
Route the wires exiting the top of the fan motor assembly
(D) through the rubber gasket (GG) aligning the holes in the
rubber gasket (GG) with the three screw holes in the fan-
motor assembly (D).
□
Route the wires exiting the top of the fan motor assembly
(D) through the canopy ring (JJ), and the canopy (C) (make
sure the slot openings for the canopy ring and canopy are
on top). Place the canopy (C) over the collar (P) at the top of
the motor assembly (D).
□
Align the mounting holes with the holes in the motor (D)
A
and fasten, using the three screws and lock-washers (LL)
removed previously. Tighten the mounting screws securely.
II
C
LL
JJ
KK
JJ
LL
8
C
GG
P
D