Condensation; Windows; Disassembly; Warranty - Dometic Winter AIR PVC Manual De Instalacion Y Uso

260 S, 260 L

9.5 Condensation

NOTICE!
Prevent condensation!
• Do not use an open flame or cook in the AIR Awning.
1. Ventilate daily.
2. Lay out a ground cover to prevent condensation.

9.6 Windows

1. Check the windows for snow accumulation.
2. Remove snow accumulations from the windows.

10 Disassembly

1. Check that the isolation valves (fig. d, on page 5) are open (these should remain open and normally do not need to
be adjusted).
2. Remove the roof lining.
3. Remove the rear upright poles and the snow support poles.
4. Remove the ground cover (if fitted (optional)).
5. Close all doors.
6. Remove the storm straps.
7. Remove all pegs.
8. Open all deflation valves (fig. 4 1, on page 2).
NOTE:
When fitted to a cassette awning, this may need to be unrolled a little. Ensure that the cassette awning is
supported during the operation.
9. Pull the AIR Awning carefully out of the rail (keder strip).
10. Place the AIR Awning on a clean surface if possible (ground cover).
11. Remove any dirt (leaves, grass, e.g.).
12. Align the AIR Awning for the folding process.
13. Place all guying straps that they can be folded in.
14. Hold the AIR Awning with two people at the storm strap points and fold it (fig. h, on page 6).
– Put the AIR Awning on the ground so that the outside of the roof lies on the ground. Fold the corners inwards so that a
rectangle is formed.
– Roll up the AIR Awning in the direction of the outlet valves under light pressure.
15. Lift the AIR Awning package into the transport bag and pack it.
16. Pack the accessories (hand pump, curtains e.g.) also into the transport bag.
NOTE:
The AIR Awning must dry completely before storage. If necessary, allow to dry out in a warm and dry, well-
ventilated room.
11

Warranty

The statutory warranty period applies. If the product is defective, please contact your retailer or the manufacturer's branch in
your country (dometic.com/dealer).
For repair and warranty processing, please include the following documents when you send in the device:
• a copy of the receipt with the purchasing date.
• a reason for the claim or description of the fault.
The warranty covers manufacturing defects, materials and parts. The warranty does not cover fading of the cover and wear and
tear due to UV radiation, misuse, accidental damage, storm damage, or permanent, semi-permanent or commercial use. It
does not cover any resulting damage. Please contact your dealer for claims. This does not affect your statutory rights.
EN
4445200196
Disassembly
15