Alarm Setting; Sleep Function - Trevi DS 1976 V Guia Del Usuario

ALARM SETTING

The device is equipped with 2 alarms. To set the alarm 1, 2 or both, follow the steps below:
1. Put the unit in Stand-by mode.
2. Press the button ALARM1(18) on the remote control. The word "Alarm1" blink and appear
"OFF".
3. Press and hold for a few seconds the FUNCTION/ALARM button (11) on the unit, the word "OFF"
blinks.
4. Press the 9(7) or :(9) on the unit to activate the alarm function by shifting the writing of "ON".
5. Press the FUNCTION/ALARM button (11) to confirm.
6. Press the 9(7) or :(9) on the unit to select the source (Radio, USB, Buzzer) from use as an
alarm clock. Press the FUNCTION/ALARM button (11) to confirm.
7. Use the 9(7) or :(9) to set the hour. Press the FUNCTION/ALARM button (11) to confirm.
8. Use the buttons 9(7) or :(9) to set the minutes. Press the FUNCTION/ALARM (11) to confirm.
The word "Alarm 1" remains fixed on the display to indicate its activation
To set the alarm 2, press and hold the button for a few seconds ALARM2(20) on the remote
control and repeat steps 3 through 8 above.
To disable the alarm
1. Press and hold for a few seconds the ALARM1 button (18) on the remote control. There
written "Alarm1" and the word "ON" will flash.
2. Press the 9(7) o :(9) n the unit to select "OFF".
3. Press ALARM1(18) on the remote control to confirm.
OFF THE ALARM
To disarm the alarm (Buzzer, USB or Radio), press FUNCTION/ALARM(11) on the unit to stop
completely.
If you want to silence the alarm, press the ON/OFF, VOL, BASS/TREBLE(12) knob on the unit; the
interruption lasts 9 minutes, after which the alarm will turn on again.

SLEEP FUNCTION

The SLEEP(35) button on the remote control allows you to program the automatic shutdown of
the unit up to 90 minutes after activation. This function is activated when the unit is turned on.
Adjust the sleep time by pressing SLEEP(35) several times; the minutes are allowed:
90, 80, 70, 60, 50, 40, 30, 20, 10, 00 (SLEEP OFF).