upside down or onto elements that could yield to its weight
If necessary, add reinforcements to the fastening points
• Do not install if the gate-leaf is not level • Check that
no lawn watering devices spray the operator with water
from the bottom up • Suitably section off and demarcate
the entire installation site to prevent unauthorized persons
from entering the area, especially minors and children • Affi x
the warning signs wherever necessary and the gate leaf so
that it is clearly visible • Use proper protections to prevent
mechanical hazards when people are loitering around the
machinery's range of action, for example avoid crushing of
fi ngers between the drive shaft and the mechanical stops,
avoid crushing when the gate is opening • The electrical
cables must run through the cable glands and not touch any
parts that may overheat, such as the motor, transformer,
and so on • All command and control devices must be
installed at least 1.85 m from the perimeter of the gate's
range of action or where they cannot be reached through
the gate from the outside • All switches in maintained action
mode must be positioned so that the moving gates leaves,
the transit areas and vehicle thru-ways are completely
visible, and yet the switches must be also away from any
moving parts • Unless a key switch is used, all control
devices must be fi tted at a height of at least 1.5 m and
where they are not accessibleto thepublic • Before handing
over to users, check that the system is compliant with
the 2006/42/CEuniformed Machinery Directive.Make sure
that the operator has been properly adjusted and that the
safety and protection devices, and the manual release, are
working properly. Make sure you have instructed the end-
users of the residual risks associated with operating the
operator itself • Make sure to hand over to the end user, all
operating manuals for the products that make up the fi nal
machinery • Set up a suitable dual pole cut off device along
the power supply that is compliant with the installation
rules. It should completely cut off the power
to category III surcharge conditions
be exclusively powered by very low safety voltage, which
corresponds to what is stated in the markings on the motor
itself, and by using the control panel supplied in the KIT.
supply according
• The gearmotor must