Installation - Glacier bay FW0AC000CP Guía De Instalación Y Cuidado

Installation

1
Installing the faucet assembly
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
Shut off the water supply. Remove the old faucet.
Clean the mounting surface.
Place the faucet (J) through the mounting holes in
the sink.
Ensure the slot openings of the rubber spacer (F)
and metal spacer (G) face toward to the rear of
the sink.
Secure the faucet (J) to the sink using the lock
nut (H) provided.
J
F
G
H
2
J
F
G
H
H
4
Installing the faucet handles
Remove the preassembled guide washers (E), metal
washers (D) and rubber washers (C) from the hot and
cold faucet handles (A and K).
Loosen the screws on the guide washers (E) until
the ends of the screws are flush with the face of the
guide washers (E).
Insert the hot faucet handle (A) to the left of the spout
and cold faucet handle (K) to the right of the spout.
Attach the faucet handles (A and K) underneath the
sink using the rubber washers (C), metal washers (D)
and guide washers (E). Securely tighten the screws on
the guide washers (E).
A
A
C
D
E
E
K
K
E