Maintenance And Cleaning - Mestra MULHACEN R-080093 Manual Del Usuario

3. Take proper safety measures. Always wear:
- Use safety goggles.
- Use safety gloves.
- Use a face-mask
- Proper clothes. No baggy clothes, ties,
necklaces, rings, bracelets or elements that
could be hooked by the machine.
- Be careful with long hair.
4. Turn on the main switch placed in the upper
part of the unit. The motor will start up and the
operation light (E) will lit up.
5. Open the water stopcock. Then use the tap
knob of the trimmer (G) to obtain the desired
water flow.
6. Place the model to be trimmed on the table (B).
For a greater precision while trimming, the table
has a set of marks to be used as reference to
determinate the cutting angles.
7. When the work is over, turn the main switch off.
8. After operating the trimmer, it is strongly
recommended to clean the table and the front
casing with a dump cloth to remove the remains
of plaster.
ABRASIVE DISC REPLACEMENT
When the abrasive element tears or wears out it
must be replaced. MESTRA spare-parts should be
always used, since they are the only ones that
assure a perfect balance of the unit and top quality.
To replace the disc, proceed as follows:
1. Open the lock (F) and the front cover. The
safety micro-switch will prevent an eventual
start-up of the motor.
2. Remove the worn out disc and place a new
one. Make sure it is properly centered.
3. Close the cover again, making sure the lock (F)
is properly closed.
ALUMINIUM PLATE MAINTENANCE
If plaster accumulates in the back of the aluminum
plate, then the machine could vibrate. Then
proceed to clean as follows:
1. Open the lock (F) and the front cover. The
safety micro-switch will prevent an eventual
start-up of the motor. For extra safety,
disconnect the unit from the power source and
close the water stopcock.
2. Remove the abrasive disc.
3. Use the Allen spanner to unscrew the bolt that
fixes the disc to the motor shaft.
4. Remove the extraction bolt from the back of the
unit and screw it up in the middle of the plate.
Then pull the screw and extract the plate.
5. Dip the plate in water, remove the plaster with a
brush and dry.
6. When you place the plate again, do not forget
the pin that couples it to the motor.

MAINTENANCE AND CLEANING

To ensure a correct,
performance of the unit we strongly recommend:
After using the unit, clean the dust and plaster
remains from the table (B) and the front cover.
Do not use alcohol or any other solvent to clean
the unit.
Never immerse the unit in a liquid.
If you notice unusual noises or vibrations, send
the unit to a technical assistance service.
Replace the abrasive disc whenever you notice
a significat fall in performance.
After replacing the disc, check that there are not
unusual vibrations.
The unit has been designed to operate correctly
leaning on the four rubber blocks in its base.
These elements are strong enough to bear the
movement of the trimming.
English
reliable and durable
9