Adjusting The Guard; Work Instructions; Rough-Grinding - Tyrolit AGE125 Manual De Instrucciones

Switching on and off
Brief operation without engaged switch
rocker
Push the switch rocker forwards and hold

in position.
To switch off the power tool, release

the switch rocker.
Continuous operation with engaged
switch rocker
Push the switch rocker forwards (1.) and

engage by pressing the front end (2.).
To switch off the power tool, release the

switch rocker by pressing the rear end.
NOTE
Following a power failure, the switched on
power tool does not restart.
24
CAUTION!
Risk of injury due to destruction of the tool.
Use the appropriate tool for the job.
NOTE
If an overload or overheating occurs during
continues operation, the power tool auto-
matically reduces the speed until the power
tool has cooled down adequately.

Adjusting the guard

To adjust the tool to the task at hand, the
guard hood can be adjusted by 12 notches
on 360° without a tool.
CAUTION!
Risk of injury! Wear protective gloves.
Pull out the mains plug.

Turn guard hood opposite to the

direction-of-rotation arrow on the gear
head to the required position.

Work instructions

NOTE
When the power tool is switched off,
the grinding tool continues running briefly.

Rough-grinding

WARNING!
Never use cutting-off wheels for rough-
grinding.
– Angle of wheel 20–40° for best cutting
performance.
– Applying moderate pressure, move the
angle grinder backwards and forwards.
As a result, the workpiece will not
become too hot and there will be no
discoloration; nor will there be any
grooves.
TYROLIT
AGE125