Instructions For Use; Attach The Guard - Tyrolit AGE125 Manual De Instrucciones

TYROLIT

Instructions for use

WARNING!
Before carrying out any work on the angle
grinder, always pull out the mains plug.
Before switching on the power tool
Unpack the angle grinder and check that
there are no missing or damaged parts.

Attach the guard

WARNING!
When using the angle grinder for roughing or
cutting, never work without the guard.
A special cutting guard must be used for cutting.
Pull out the mains plug.

Attach the guard (1.). Lugs on the guard

hood must be located in the flange
recesses (2.).
Turn guard hood clockwise.

Rotation is possible in one direction only!
Remove in reverse order.

Attach the handle
AGE125
NOTE
It is not permitted to operate the electric
power tool without the handle.
Attaching/changing the tool
Pull out the mains plug.

Attach the grinding wheel
Press and hold down the spindle lock (1.).

Using the face spanner, loosen the

clamping nut on the spindle in an anti-
clockwise direction and remove (2.).
Insert the grinding wheel in the correct

position.
Screw the clamping nut with flange face

up, onto the spindle.
Press and hold down the spindle lock.

Tighten the clamping nut with the pin

wrench or stop key.
Carry out a test run to check that the tool

is clamped in the centre.
Test run
Insert the mains plug into the socket.

Switch on the angle grinder with the

switch (without engaging it) and run the
angle grinder for approx. 30 seconds.
Check for imbalances and vibrations.
Switch off the angle grinder.

23