Onboard Tool Storage; Adjustable Clamp Pressure - Kreg 700 Serie El Manual Del Propietario

Ocultar thumbs Ver también para 700 Serie:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Onboard Tool Storage

The KPHJ720 Jig (A) provides onboard
tool storage for these items:
■ Easy-set pocket-hole drill bit (E) with
easy-set stop collar (F) attached
■ Material thickness gauge/hex
wrench (D)
■ 3" and 6" driver bits (G)

Adjustable Clamp Pressure

A knob (1) on the side of the KPHJ720 Jig enables you to increase or decrease the
clamp pressure that is applied to your workpiece. Five pressure settings are available.
The jig ships from the factory with the clamp pressure at the middle setting.
To adjust the clamp pressure:
a. Lift the jig handle all the way up to
release the clamp pressure.
b. Rotate the clamp-pressure
adjustment knob (1) one click in the
desired direction:
■ Clockwise to decrease pressure
■ Counterclockwise to increase
pressure
c. With a test block in place, reapply the clamp pressure by pressing the jig handle
down in one smooth motion until the jig handle is at its travel limit.
d. Repeat this process as needed until you are satisfied with the clamp pressure.
Note
■ The jig is set to minimum clamp pressure when the "minus" sign on the clamp-
pressure adjustment knob (1) aligns with the selection mark (2).
■ The jig is set to maximum clamp pressure when the "plus" sign on the clamp
pressure adjustment knob (1) aligns with the selection mark (2).
4
F
E
D
G
A
2
1
Tabla de contenido
loading

Productos relacionados para Kreg 700 Serie

Este manual también es adecuado para:

720proKphj720Kphj720pro

Tabla de contenido