Kreg 700 Serie El Manual Del Propietario página 15

I
Adjustable stop (1) in centered configuration
for wide workpiece
b. Place the adjustable stop (1) onto the lid of a material support wing (I) so that:
■ The edge of the adjustable-stop arm (J) rests snugly against the workpiece.
■ The notch (2) on the underside of the adjustable stop base fits over the rail (3)
that runs across the lid of the material support wing (I).
c. Rotate the adjustable stop knob (K) clockwise until tight to secure the adjustable
stop (1) in position.
Note To reposition or remove the adjustable stop (1), rotate the adjustable stop
knob (K) counterclockwise to loosen it. Then slide the adjustable stop (1) to a new
position along the rail (3) or lift it off of the material support wing (I).
1
Adjustable stop (1) in side configuration
for narrow workpiece
I
A
I
J
K
1
2
3
1
15