Uline H-5048 Manual Del Usuario página 4

1. Unlatch the three clamps on top of the vacuum
and remove cap. Remove micro cloth filter and
Intercept® Micro Filter. (See Figure 3)
Figure 3
2. Check to make sure the dome filter did not shift
during shipping. (See Figure 4)
Figure 4
3. Replace the Intercept® Micro Filter and the micro
cloth filter into the vacuum. Replace the cap and
relatch the three clamps.
4. Push the hose into the cap opening. (See Figure 5)
Figure 5
WAND ASSEMBLY
1. Fasten the pieces of the wand together. Open purple
latch on lower half of wand. Align notch on inside of
lower half with groove on outside of upper half and
push pieces together. Adjust wand to desired height,
then close the purple latch to secure the position.
(See Figure 6)
Figure 6
Purple Latch
PAGE 4 OF 24
ASSEMBLY
2. Twist the wand into the end of the hose. (See Figure 7)
3. Attach the floor tool to end of wand. Align the brass
ring with the groove on the floor tool to ensure a
secure fit. (See Figure 8)
HARNESS HEIGHT ADJUSTMENT
1. Upper harness should sit between shoulder blades
for most comfortable fit. The vacuum is shipped with
the upper harness in the middle position. Tall users will
need to move the position up. Shorter users will need
to move the position down. (See Figure 9)
2. To move the upper harness, loosen the tensioning
straps. Then, using a #3 Phillips screwdriver, remove
the screw located in center of upper harness.
(See Figure 10)
Figure 10
3. To ensure that the upper harness is secure, tighten
the screw until it's all the way in.
Figure 7
Figure 8
Figure 9
Move up
for tall
Adjustable
users.
Move
down for
short users.
Upper Harness
Harness Height Adjustments
Tensioning Straps
Pivoting Bar
0421 IH-5048