Acquisition Procedure - Roger Technology B70/1DC Manual De Instrucciones

TEST
1 click
CLOSE
11.2

Acquisition procedure:

PROG
AP P-
x4 s
OPENING OPEN
• Press and hold PROG for 4 seconds.
• Open the release handle. The message
launches a calibration procedure. The operating parameters of the motor are determined during calibration.
• If the motor calibration procedure is successful, the message
• Close the release handle. The acquisition procedure now starts.
• is shown on the display (only if parameters
photocell beam within 5 s, to prevent interrupting the procedure.
• is shown on the display and the gate starts opening at low speed.
•
• The gate closes until it reaches the gate closed limit switch.
If the acquisition procedure is completed successfully, the display enters the command and safety device state
display mode.
If the following error messages are shown on the display, repeat the acquisition procedure:
• : calibration procedure failed.
• : acquisition error. Press the TEST button to clear the error, and check the safety device in alarm state.
• : travel length error. Press the TEST button to clear the error, and check that gate is completely closed.
For more information, see chapter 17 "Alarms and faults".
72
TEST
15 15
No
TEST
da da ta ta
No
YES
TEST
fC fC
PH A5
PH A5 PH
Wait ...
AU to AU to
is shown on the display.
appears on the display after a few seconds. The controller unit
SEE CHAPTER 16 and 17
1 click
Until ...
PROG
AP P-
1 click
Press and hold on
ACQUISITION
PROCEDURE
CHAP. 11.2
1 click
A5
(if FT input are
connected or enabled)
CLOSING CLOSE
, , , are not disabled). Keep away from the
ACQUISITION
PROCEDURE
CHAP. 11.2
FO TO FO TO
AU to
Yes