Warn 74500 Manual Del Usuario página 8

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

WARNING
TO PREVENT SERIOUS INJURY
OR DEATH FROM EXPLOSION:
Do not drill into gas tank.
Verify the area is clear behind the
mounting location before drilling.
Programming LED
Programming button
Warn Industries, Inc.
6
STEP 2: MOUNT THE RECEIVER
What is the receiver?
The receiver is a vital safety component of your wireless
winch system. It disconnects the winch from its power source
when the ATV is not in use. The receiver must be correctly
installed to work properly.
The receiver should be mounted in a location that is as clean
and dry as possible while also allowing access to the
programming button. The mounting location must also
provide clearance for the wire harness to attach to the
receiver.
Best locations for the receiver will vary depending on the
ATV. Typical locations include the inside, top, or side of the
rear storage box or under the seat. The receiver can be
attached to a flat surface or to a frame tube of the ATV.
Mounting Steps:
1. Determine the mounting location.
2. If mounting on a flat surface, mark and drill a minimum of
two (2) mounting holes, one on each side of the receiver.
3. Loosely attach the receiver using 1/4-inch or M6 bolts and
locknuts.
4. If mounting on a frame tube, loosely attach using the wire
ties supplied.
5. Do not tighten fasteners at this time.
Minimum of one fastener on each side
STEP 3: ROUTE THE HARNESS
Locate the BLACK and GREEN wires running from the
contactor to the handlebar switch. Find the bullet connectors
on these wires located near the contactor.
Plan a route for the wire harness between the receiver and
these bullet connectors.
Tabla de contenido
loading

Este manual también es adecuado para:

74600

Tabla de contenido