Operating Components - Promaker PRO-SB1800 Manual Del Usuario

The easy-to-read scale
BEVEL SCALE -
on the front of the cabinet shows the
exact angle of the blade.
This saw is equipped with a
BLADE -
10 inch 24 tooth carbide blade.
The blade is raised and lowered with
the height / bevel adjustment wheel.
Bevel angles are locked with the bevel
lock lever.
WARNING!
Do not use blades rated lower
than
tool.Failure
warning personal injury.
BLADE GUARD
removable blade guard on the saw
blade for sawing cuts.
HEIGHT/BEVEL ADJUSTING HANDWHEEL
Located on the front of the cabinet,
-
use this handwheel to lower and raise
the blade for height adjustments or
blade replacement.
This steering wheel also makes it easy
to adjust for bevel angles.
MITER GAUGE -
the wood for a cross cut.
The easy-to-read indicator shows the
exact angle for a miter cut.
MITER SLOTS -
into the slots in the saw table.
CUTTING GUIDE -
guides the workpiece and is secured
with the locking lever.
the speed of this
to follow this
could result
Always keep the
-
The miter guide aligns
The miter gauge fits
A sturdy metal guide
DIVIDER KNIFE -
piece of the blade guard, slightly thinner
than the saw blade, which helps keep
the cut open and prevent kickback.
When it is in the middle of sawing, or in
the "up" position, it is higher than the
saw blade. When it is in the no saw, or
"down" position, it is below the teeth of
the saw blade.
SCALE -
easy-to-read scale provides accurate
measurements for fine cuts.
SWITCH MOUNTING -
in
an easily accessible power switch
located under the front rail. To lock the
switch in the OFF position, remove the
key from the switch. Place the wrench
in a place inaccessible to children and
others not qualified to use the tool

OPERATING COMPONENTS

The top of the blade protrudes through
the table and is surrounded by an insert
called a table top. The height of the
sash is adjusted with a steering wheel
on the
accommodate the wide panels, the saw
table has rails on each side. Detailed
instructions for basic cuts are provided
in the Operation section of this manual:
cross cuts, miter cuts, bevel cuts, and
compound cuts. The cutting guide is
used to position the workpiece in
longitudinal cuts.
A scale on the front rail shows the
distance between the cutting guide and
the blade. It is very important to use the
blade guard assembly for all continuous
cutting
assembly includes: riving knife, anti-
kickback
protector.
A removable metal
Located on the front rail, the
This saw has
front of the
operations. Blade
pins, and plastic
cabinet. To
guard
sheet
8