General Maintenance - Promaker PRO-SB1800 Manual Del Usuario

MAINTENANCE
WARNING!
When making repairs, use only
identical replacement parts. The
use of any other part may create a
hazard or cause damage to the
product.
WARNING!
Always wear
goggles with side shields when using
power tools or blowing dust. If the
operation is dusty, also wear a dust
mask.
WARNING!
Before performing any maintenance,
make sure the tool is disconnected from
the power source and the switch is in
the off (O) position. Failure to heed this
warning could result in serious personal
injury.

GENERAL MAINTENANCE

Avoid using solvents when cleaning
plastic parts.
susceptible to damage from various
types of commercial solvents and
can be damaged by their use. Use
clean cloths to remove dirt, dust, oil,
grease, etc.
safety glasses or
Most plastics
WARNING!
Do not allow brake fluids, gasoline,
petroleum-based products, oils, etc.,
to come into contact with plastic parts
at any time.
Chemicals can damage, weaken, or
destroy plastic, which can lead to
serious personal injury.
• Periodically check all clamps, nuts,
bolts, and screws for tightness and
condition. Make sure the table insert
is in good condition and in position.
• Check tthe mounting of the blade
guard.
• To maintain table, guide and rail
surfaces, periodically apply paste
wax and polish to provide smooth
operation.
• Protect the blade by cleaning
sawdust under the table and on the
blade teeth. Use a resin solvent on
the teeth of the blade.
• Clean plastic parts only with a soft,
damp cloth. DO NOT use aerosol or
petroleum solvents.
• LUBRICATION
All bearings in this tool are lubricated
are
with a sufficient amount of high-grade
lubricant for the life of the unit under
normal operating conditions.
Therefore, no additional lubrication is
required.
32