Promaker PRO-SB1800 Manual Del Usuario página 14

• Unplug the saw.
• Raise the saw blade by turning the
bevel / height adjustment wheel to the
right.
• Place the dividing knife in the "up"
position.
• Reinstall the table insert.
To install anti-kickback pawls:
• Press and hold the button on the
right side of the anti-kickback pawls.
• Align the slot in the pawls over the
rear hole in the riving knife.
• Push the
snapping them
release the button.
NOTE: Pull on the ratchet handle to
make sure the ratchets are securely
locked.
pawl handle down,
into place
TO INSTALL THE BLADE GUARD:
• Lift the safety lever to unlock it.
• With the front of the blade guard
raised, lower the rear of the guard into
the middle hole of the riving knife. Push
the front of the guard down until it is
parallel to the table (see figure 15). If
the blade guard is not parallel to the
table, the dividing knife is not in the "up"
position.
• Lock the guard in place by pressing
the safety lever down.
NOTE:
adjusted for different blade widths.
See: To Check and Align the Divider
and
Knife and Saw Blade. Check blade
guard assembly for clearance and free
movement.
TO CHECK AND ALIGN THE
DIVIDER KNIFE AND SAW BLADE
See Figures 16 - 17.
To check alignment of the
dividing knife:
• Unplug the saw.
• Raise
turning
adjustment wheel to the right.
• Remove the anti-kickback pawls
and blade guard assembly. Place a
carpenter's square or straight edge
against both the saw blade and the
riving knife
NOTE: Place the carpenter's square
between the carbide teeth and the
blade. This step will ensure that the
carpenter's square is straight against
the blade from the front to the back of
the blade.
Blade alignment can be
the saw blade
the bevel
by
/ height
14