Operation And Maintenance - Westinghouse Great Falls Manual Del Usuario

OPERATION AND MAINTENANCE

Operation
Turn on the power and check operation of fan. The pull chain controls the fan speeds as follows: 1 pull - high; 2 pulls - medium; 3 pulls - low; 4 pulls - o .
Speed settings for warm or cool weather depend on factors such as room size, ceiling height, number of fans and so on. The slide switch controls direction, forward or reverse.
Warm weather/down position - (Forward) Fan turns counterclockwise direction. A downward air ow creates a cooling e ect as shown in illustration A.
This allows you to set your air conditioner on a higher temperature setting without a ecting your comfort.
Cool weather/up position - (Reverse) Fan turns clockwise direction. An upward air ow moves warm air o the ceiling area as shown in illustration B.
This allows you to set your heating unit on a lower setting without a ecting your comfort.
NOTE: Turn o and wait for fan to stop before changing the setting of the forward/reverse slide switch.
Maintenance
1. Because of the fan's natural movement, some connections may become loose. Check the support connections, brackets, and blade attachments twice a year.
Make sure they are secure.
2. Clean your fan periodically to help maintain its new appearance over the years. Do not use water when cleaning.
This could damage the motor, or the wood, or possibly cause electrical shock.
3. Use only a soft brush or lint-free cloth to avoid scratching the nish. The plating is sealed with a lacquer coating to minimize discoloration or tarnishing.
4. There is no need to oil your fan. The motor has permanently lubricated bearings.
23
Attach the light kit to the switch housing by placing the keyslot holes from the light
kit onto the two protruding screw heads from the switch housing. Twist the light kit
until the screwheads engage the keyslots. Install the screw removed from the switch
housing (step 22) into the closed hole in the light kit. Tighten all screws to complete
attachment of the light kit.
Fije el juego de luces al alojamiento del interruptor colocando las ranuras del juego
de luces sobre las dos cabezas de los tornillos que sobresalen del alojamiento del
interruptor. Gire el juego de luces hasta que las cabezas de los tornillos enganchen en
las ranuras. Coloque el tornillo que extrajo del alojamiento del interruptor (paso 22)
en el agujero cerrado del juego de luces. Ajuste todos los tornillos para completar la
instalación del juego de luces.
22
ETL-ES-GreatFalls-WH15