Install Door Panels - JENN-AIR JS42NXFXDW Guia De Instalacion

Ocultar thumbs Ver también para JS42NXFXDW:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

5. Attach a mounting bracket to the top edge of each door panel
by placing the large end of the keyhole slot over the screws
and sliding the bracket so that the screws are centered in the
slots.
NOTE: Start with the screws in the center of the slots as
shown, then move the door panel, as necessary, to align.
A
A. Door panel
Top Grille Panel
1. Using the slotted hex head screws (provided with refrigerator),
attach a mounting bracket to each side of the top grille panel.
IMPORTANT: See the Parts Provided insert sheet to select
the brackets designated for your installation.
Use the Integrated Grille brackets for an Integrated
Installation with a full height grille.
Use the Standard Grille brackets for a Standard
Installation with a closed or open soffit.
A. Top grille brackets
B. Grille trim piece
2. Using round head screws (provided with refrigerator), attach
the grille trim piece to the bottom of the grill panel.
NOTE: The grille trim is pre installed on the panel kits.
Remove Trim Pieces
1. Remove all tape and door bracing from the refrigerator and
freezer doors.
2. Open the refrigerator and freezer doors.
3. Remove the hinge cover pieces from the top and bottom of
the door to expose the holes in the hinges.
NOTE: It is not necessary to remove the hinge side trims as
they will not interfere with the installation.
B
B. Mounting bracket
A
B
4. Remove the handle side trims. See the following graphic.
A
B
A. Hinge cover pieces
B. Handle-side door trim

Install Door Panels

NOTE: First open the door opposite from the one to which you are
installing the door panel.
1. Lower the panel mounting bracket onto the adjustment pins at
the top of the door.
C
A. Door panel
B. Mounting bracket
2. Locate the studs on the back of the door panel. Slide the
studs, top stud first followed by the bottom stud, into the "J"
pockets in the front of the door.
NOTE: It is the washer in the stud, not the head of the stud,
that is inserted in the "J" pocket.
3. Slide the door panel down, into the "J" pocket in the front of
the door.
A
B
A
A
B
C. Adjustment pins
21
Tabla de contenido
loading

Tabla de contenido