Settings Menu - Warn ZEON Guía De Instalación Y Operación

Settings Menu

From your Setting menu, you are able to adjust
screen brightness, pair your remote, link auxiliaries
to your high beam setting and turn on the thermal
shut-off option.
Activate the Settings Operation Menu
1. From the Home Menu, navigate to the Settings
Icon and press Select.
Select
Adjust Brightness
1. To adjust the brightness, navigate to the
Brightness Icon and press Select.
Brightness
Icon
Select
2. Use the Left and Right buttons to adjust slider
to the desired brightness. Once the brightness
is at the desired level, press Select to close the
brightness adjust panel.
Select
FIRST TIME OPERATING INSTRUCTIONS
Link Auxiliary High Beam
With your Advanced Wireless Remote, you are
able to link your auxiliaries to your vehicle high
beam setting.
1. To link the auxiliary (1 or 2) with your vehicle's
high beam setting, navigate to the Auxiliary 1 or
2 Icon and press Select.
Auxiliary 1
2. The auxiliaries default as unlinked.
3. Using your left or right button to highlight the
"linked" icon. A check mark will appear in the
box. Press select to confirm selection.
Auxiliary 1
Linked
Note: Images show linking Auxiliary 1. Same process
will be used for Auxiliary 2 linking.
WARN INDUSTRIES
19
FIRST TIME OPERATING INSTRUCTIONS
Pairing the Remote Control
Never pair more than one winch and one
WARNING
remote at a time.
Your Advanced Wireless Remote Control will
arrive already paired to your WARN® ZEON®
Platinum winch system, however, replacement
remotes will need to be paired.
1. To pair the remote to a winch, navigate to the
Auxiliary 2
Pairing Icon and press Select.
Pairing
Icon
Select
2. Press and hold select and the right button
Auxiliary 1
simultaneously for 3 seconds to bring up the
Unlinked
pairing confirmation menu.
3. To continue pairing, select the green check
mark icon by navigating with the left or right
buttons and press Select.
Select
92821A3 92821A3
4. After selecting the green check mark icon,
a timer will begin counting down from 30
seconds.
5. During this time, turn the Wireless Control
Activation Switch on the back of the control
pack to OFF and then ON again.
Select
6. If pairing is successful, a green check mark will
appear.
Right
Button
Select
7. If pairing was unsuccessful, the red X mark will
remain, and the remote will remain unpaired.
Select
WARN INDUSTRIES
20
Wireless
Control
Activation
Switch