4-4.Wiring For The Receiver; 4-5.Installing The Receiver/Operation Panel - Panasonic CZ-RWSU2N Manual Del Usuario

Wiring Diagram
Terminals for RC
wiring
How to Connect the Wires
1 Connect the remote controller wiring to the terminals for RC wiring on the indoor unit.
(No polarity)
2 Connect the receiver and the operation panel with the receiver wiring.
4-5. Installing the Receiver/Operation Panel
Resin Panel
Installing the Operation Panel
1 Remove the 2 screws. Then remove the cover A from the back of the panel. (Fig. A)
2 Fasten the operation panel to the location shown in the figure below with the 2 supplied screws
(4 × 10). (Fig. B)
3 Pass the receiver wiring (6P white connector) through the back of the panel.
Fig. A
Installing the Receiver
1 The cover B is fitted in the cover A. Remove the 1 screw and detach it by pressing from the front
side of the panel. (Fig. C)
2 Connect the receiver wiring (6P white connector) that is sticking out from the operation panel to
the receiver and fit the receiver into the panel.
Make sure the 6P white connector is fully plugged in all the way.
3 Bend the lead wire of the receiver into shape so that it does not come in contact with the louver
shaft.
There is a groove to pass the wire (circled part in Fig. C). Insert the lead wire into this groove
with no slack.
4 Attach the cover A until it is firmly engaged in the claws indicated by arrows. (Fig. D)
5 Arrange the lead wire of the operation panel appropriately and fasten it with the supplied
clamper.
6 Install the ceiling panel.
Fig. C
4-4. Wiring for the Receiver
Indoor unit
Operation panel
RC
wiring
1
2
Cover A
Cover B
Receiver wiring
CN2
CN1
2P white
6P white
Fig. B
Receiver wiring
Receiver
Fig. D
Connect
CZ-RWSL2N
Receiver
CN1
6P white
Supplied screws
(4 × 10)
Operation
panel
11