How To Replace Receiver; Maintenance; How To Clean Your Ceiling Fan Blades - Fanimation The Jennix FPD7943 Serie Manual Del Propietário

Ventilador de techo

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

How to Operate Your Ceiling Fan (Continued)

5. "D" and "ON" dip switch:

The "ON" selection is the light dimmable selection and is to

be used with all bulbs other than CFL. The "D" selection is

the light on only (no dimming function) and is to be used

with CFL bulbs (as CFL bulbs cannot be dimmed). The

receiver provides the following protective function:

(Figure 5)

Lock position: The DC motor has a built-in safety feature

against blade obstruction against obstruction during

operation. If something obstructs the fan blades the motor

will stop operating after 30 seconds of interruption. Please

remove obstacles and reset.

Over 80W protection: When the receiver detects motor

power consumption which is greater than 80W, the

receiver power will shutdown and fan operation will cease.

Disconnect the power supply and after 5 seconds return-

power on to the fan.

1. Remove cover housing upper by unscrewing the

two screws. (Figure 1)

2. Unplug signal wire and 9-pin connector than replace

new receiver. (Figure 2)

3. Tight the two screws from the cover housing upper.

(Figrue 3)

4. After installing new receiver to your fan, operate the

remote "Code Setting" process on "How to operate your

ceiling fan" Step 3 again.

1. Periodic cleaning of your new ceiling fan is the only

maintenance that is needed. When cleaning, use

only a soft brush or lint free cloth to avoid

scratching the finish. Abrasive cleaning agents are

not required and should be avoided to prevent

damage to finish.

How to Clean Your Ceiling Fan Blades

Periodic light dusting of the blades is recommended.

A feather duster will work best.