Getting Started - Husqvarna Automower 310 Manual De Usuario

28.1 Introduction
28.1.1 Description
®
Automower Connect brings the menu system
to your mobile device, making it easy to read
and change the product settings remotely.
Through this application, you can receive the
current status of the product and send
commands to the product from anywhere in
the world. In case of theft, you get an alarm
and can monitor the position of the product.
28.1.2 Installation
®
The Automower Connect accessory must be
installed by a dealer. The installation includes a software update of the product.

28.2 Getting started

You can communicate with your product
through the mobile application Automower
Connect. With Automower
activated, new symbols will show on the
display of the product.
Note:
All countries do not support
®
Automower Connect because of legal
reasons and regional specified cellular
systems. The included Automower
lifetime service only applies if there is a third
part sub-supplier of 2G/3G/4G available in the operational area. In some countries
®
Bluetooth is not available due to legal
reasons.
28.2.1 Download the Automower
app
Download the Automower
App Store or Google Play to your mobile
device.
28.2.2 Create an Automower
account
When you have downloaded the app, you can
enter your e-mail address and a password to
®
make an Automower Connect account. You
will receive a validation e-mail to your e-mail
address. Follow the instructions in the e-mail
1428 - 002 - 25.02.2020
28 Operators manual
®
®
Connect
®
Connect
®
Connect
®
Connect app from
®
Connect
in less than 24 hours to validate your account.
If not validated in less than 24 hours, you must
make a account again. You can pair the
product and your mobile device when the
account has been made in the app.
28.2.3 Pair with Automower
1. Start the app on your mobile device and
log in to your account.
Menu > My mowers .
2. Select
3. Push + ta add a new product. Follow the
instructions in the app.
Menu > Accessories >
4. Select
Automower ® Connect .
5. Enter the PIN code.
Pairing > New pairing in the menu
6. Select
of the product.
7. Enter the 6-digit code shown on the
display of the product.
28.3 Settings
Display and change the settings of the product
from everywhere in the world. For security
reasons you must use short-range
communication (Bluetooth
General and Security settings, or disable the
®
Automower Connect module on the product.
28.3.1 To set the GeoFence center
The GeoFence function makes it possible to
monitor the product, for example in case of
theft. Before GeoFence can be used, its
center point and sensitivity must be set. This
can only be done from the menu in the
product.
1. Put the product in the center of the work
area.
2. Select Accessories > Automower
Connect .
3. Enter the PIN code.
GeoFence .
4. Select
Activate GeoFence and push OK.
5. Select
New center point to set the source
6. Select
for GeoFence.
®
Connect
®
) if you change
®
Operators manual - 88