Ratio IR1200NM Manual De Instrucciones página 39

H1
H2
5. BEVEL CUT (SEE FIG. I1, I2)
A bevel cut is made at 0° miter and any bevel
angle in the range of 0° to 45° left.
The saw can be moved from the normal 0°
perpendicular position to an angled position down
to 45° from the horizontal, on the left only.
Loosen the bevel lock lever (19) and tilt the saw
head to the left, until the desired angle is reached
on the bevel scale. Re-tighten the bevel lock
lever and make your cut.
I1
I2
6. COMPOUND CUT (SEE FIG. J)
A compound cut is a cut requiring both a miter
setting and a bevel setting. It can be made as
either a chop cut or a cross pull cut
depending on the width of workpiece.
Compound miter cuts can be achieved by setting
both the miter and bevel angles simultaneously.
7
Follow the procedures for miter and bevel cuts to
achieve the desired angles.
MAINTENANCE
servicing or maintenance.
When all the adjustments, settings or
maintenance have been done, make sure that all
keys and wrenches have been removed and that
all screws, bolts and other fittings are securely
tightened.
There are no user serviceable parts in your
power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry
cloth. Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep all
working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This
is normal and will not damage your
power tool.
19
If the supply cord of this power tool is damaged,
it must be replaced by a specially prepared cord
available through the service.
1. PRECISION SETTING OF ANGLES (SEE
FIG. K1, K2, L1, L2)
While the machine has been factory set, it is
advisable that the 0o setting of the rotary table
and the 90o perpendicular setting of the tilt be
checked, as these positions may have moved
in transit. (Ensure power is disconnected while
making these adjustments).
To confirm the 0o rotary table setting, set the
rotary table at 0o and tighten the rotary table
J
WARNING: Remove the plug from the
socket before carrying out any adjustment,
39