Led Indicators - Tripp-Lite OMNISMART550MX El Manual Del Propietario

Installation and Operation

LED Indicators

Power Status
(Green LED)
Description
AC Line Mode
Normal Operation
AC Line Mode
Overload Alarm
AC Line Mode
Overload Fault*
AC Line Mode
Replace Battery
Battery Backup Mode
Full Charge**
Battery Backup Mode
Low Battery
Battery Backup Mode
Overload Alarm
Battery Backup
Mode Overload
Shutdown***
Fault Mode
(Short Circuit/
Overcharge, etc.)
* UPS goes to Overload Fault Status (Line Mode) when load levels of 125% or greater occur for a duration of 10
minutes and 20 seconds.
** UPS remains silent in Battery Backup Mode until low-battery notification occurs.
*** UPS goes to Overload Shutdown (Battery Mode) with load levels of 110% or greater; Shutdown occurs
within 36 seconds.
Alarm Configuration Note: The alarm is factory configured to remain silent in battery mode until the low-
battery threshold occurs.
To configure the alarm to sound immediately in response to a power failure, press and hold the POWER
BUTTON until a single beep is heard, then release. The alarm will now be configured to sound immediately
when a power failure occurs.
IMPORTANT! The Power Button must be released immediately after the first beep in order to change the
alarm off/on status. Holding the switch down until the second beep will immediately power off the UPS.
Alarm OFF/ON status can be changed as the UPS runs in AC or Battery mode. Changing alarm status
activates a UPS preset that automatically remains in place until the next reset.
ON/OFF ON BATTERY
Mode
(Yellow LED)
On Off
On Off
Off Off
On Off
Off Flashes every
10 seconds
Off Flashes every
1 second
Off Flashes every
0.5 seconds
Off Off
Off Off
5
OVERLOAD/ REPLACE
LOW BATTERY BATTERY
(Red LED) (Red LED)
Off Off
Off Off
On Off
Off On
Off Off
On Off
Off Off
Off Off
On Off
Alarm
Off
Sounds every
0.5 seconds
Sounds
continuously
Sounds every
1 minute
Off
Sounds every
1 second
Sounds every
0.5 seconds
Off
Sounds
continuously