Adjusting Fit; Making/Answering/Ending Calls - Avaya AWH55/65-USB Manual Del Usuario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 35

ADJUSTING FIT

W earing Options
Retaining
Ring
Snap speaker into retaining ring of 
desired wearing option (headband 
or earloop).
10
1.  Adjust headband to fit.
2.  Rotate headset in retaining ring 
until microphone is pointing toward 
your chin.

MAKING/ANSWERING/ENDING CALLS

To make a call:
Press the call control button on the headset. The status indicator lights on both the base 
and the headset should go on, indicating a successful link. Dial using softphone.
To answer a call:
Press the call control button on the headset to answer a call. When the ringer switch on 
the side of the base is on (in the up position), the base will ring with an incoming call – 
so you can receive notification of a call even when not wearing the headset. The feature is 
disabled when the ringer switch is in the down position.
To end a call:
Press the call control button on the headset. 
To switch between calls:
Some softphones support a feature known as "flash. "  This allows you to place the current 
call on or off hold, or to toggle between calls. To do so, rock the headset volume control 
either way for more than 2 seconds. See diagram under "Adjusting Volume, Initiating Flash" 
on page 12.
When using PerSonoCall, the radio link between the headset and the base will only be 
active during a call. This is the default setting intended to preserve the battery life of the 
headset. However, you may wish to have the radio link active when not on a call so you 
can listen to other audio sources, such as streaming audio on your PC. You can open the 
radio link at any time by pressing the call control button on the headset.
NOTE: Locking the radio link on for extended periods of time will significantly reduce the
standby and talk time of the headset.
For Softphones Not Compatible with PerSonoCall
Check the PerSonoCall compatibility list at www.plantronics.com/personocall for the most 
current information on softphone compatibility.
If your softphone is not currently supported by PerSonoCall, remote detection and answer/
end via the headset does not function. Pressing the call control button on the headset 
will only open and close the radio link providing audio; you must answer the call from 
the softphone.
11
Tabla de contenido
loading

Tabla de contenido