Setup; Charging; Positioning - Avaya AWH55/65-USB Manual Del Usuario

SETUP

1
To install base unit, first thread the USB cable through the bottom of the base so it rests
in notch. Then attach the stand by inserting the stand pegs into the holds on the underside
of the base unit.
2
Connect USB connector to a free USB port on your computer. A USB hub can be used
but be sure it can supply sufficient power (250mA) to charge the headset.
Alternatively, the velcro strips included can be used to attach the base unit to a PC monitor.
However, if that causes noise or interference problems, see "Positioning" on page 7.
3
The optional AC charger can be used.
6

CHARGING

1. Slide headset into charging cradle.
2. Gently press down on the headset to ensure that headset is in correct position. Red charge
indicator light on base will illuminate while charging and will go completely off when
fully charged.
AC Charging Only:
When your computer is powered off, the AWH 55/65-USB will not charge, and the headset
standby time will decrease. Using the optional AC adapter will ensure your headset remains
charged.
USB Charging Only:
When your computer is powered on, the AWH 55/65-USB will charge via the USB connection.

POSITIONING

3 0
C M
The minimum recommended separation distance is shown above.
IMPORTANT: Incorrect positioning can cause noise and interference.
1 hour = minimum charge
to continue setup
3 hours = full charge
7