Coffee Dose Adjustment - Sanremo SR70 Libro De Instrucciones

ground too fine. Nonetheless, bear in mind that
there are many conditions liable to influence the
correct supply, such as the weight of the portions,
the compacting, the espresso machine settings, and
the cleaning of the filters.

COFFEE DOSE ADJUSTMENT

For dosing, go to FACTORY SETTINGS, select the
Grinding Time, the 1 or 2 cups' option and then
increase the grinding time with P2 or decrease it
with P1.
Grind 2 cups
Sec
GRINDER REPLACEMENT
When this electronic grinder/doser reaches the
value set in the factory for the replacement of the
grinders, a warning appears after the statistics.
BLANDES
REPLACEMENT
IMPORTANT: Partial zeroing is needed after
replacing the grinders:
O
Enter the FACTORY-SET SETTINGS and go to PAR-
TIAL ZERO SETTING and press the P1 button.
Warnings regarding operation
• Do not leave the appliances turned ON without
coffee in the hopper..
Safety devices
THERMAL OVERLOAD PROTECTION
The appliance's motor is protected against over-
heating resulting from overcurrents by a thermal
overload protection which, when tripped, cuts off
the power supply to the motor. Should the protec-
tion trip as a result of anomalous operation, such as
the grinding blades jamming, the appliance must
be turned off using the on-off switch, UNPLUGGED
FROM THE MAINS, AND SKILLED TECHNICAL PER-
SONNEL CONTACTED. NEVER PERFORM ANY
WORK ON THE APPLIANCE WHILE IT IS ATTACHED
TO THE MAINS, TO AVOID THE RISK THAT MOTOR
TURNS ON SUDDENLY.
If the appliance overheats as a result of the motor
stopping, allow the appliance to cool down before
performing any repair work.
SAFETY SCREWS
The hopper must always be attached to the upper
grinding blade hol-der using the relevant screw,
which must not be removed by the user under any
4,0
circumstances.
In order to prevent the adjustment disk from being
removed - which would make the rotating parts
accessible - there is a safety screw on the actual
disk: said screw must be positioned in whichever of
the two holes on the disk enables the wider and
most suitable range of grinding adjustment, and
must not be removed by the user under any cir-
cumstances.
COFFEE OUTLET GUARD
The coffee outlet guard must always be fixed to the
doser using the relevant screws, wich must never
be removed by the user.
The removal of the coffee outlet guard can be done
by skilled technical personnel only after disconnect-
ing the appliance from the power supply by unplug-
ging. Before reconnecting the appliance to the
power supply, fix the safety device to the doser by
the relevant screws.
Noise level
EEC Countries:
The maximum noise emission of our coffee
grinders and grinders/dosers measured in UNI EN
ISO 3741 reverberating chamber in compliance
with the EN 60704-1 regulations, is compliant with
the EN 60704-1 : 1998 and EN 607043 : 1996 reg-
ulations. The daily personal noise exposure of a
worker, due only to an appliance's limit operation
19