Davey EcoMatic COMM500 Instalación E Instrucciones De Funcionamiento página 36

Collocare la metà inferiore della ganascia del tubo sul tubo e fissarla con gli elementi di fissaggio forniti. Ser-
rare abbastanza da prevenire eventuali perdite.
Applicare il nastro in Teflon al filetto sul flussostato e avvitare il flussostato nella ganascia del tubo. Serrareil
flussostato usando la chiave di serraggio sul corpo dell'apparecchiatura. Evitare di serrare l'interruttore attra-
verso la chiusura elettrica, dal momento che può danneggiare il flussostato.
L'allineamento del flussostato è fondamentale per un funzionamento corretto. Il flussostato deve essere allineato
con la tubazione e con la freccia relativa al flusso nella direzione del flusso. Rimuovere il coperchio dellì'armadio
elettrico e inserire i cavi nell'ingresso per i cavi. Collegare i cavi ai terminali etichettati "COMM" e "NO".
Position the lower half of the pipe clamp onto the pipe and secure with the fasteners provid
to prevent leakage.
Position the lower half of the pipe clamp onto the pipe and secure with the fasteners provid
Position the lower half of the pipe clamp onto the pipe and secure with the fasteners provid
to prevent leakage.
to prevent leakage.
Apply Teflon tape to the thread on the flow switch and screw the flow switch into the pipe c
switch using the spanner flats on the body. Avoid tightening the switch via the electrical enc
damage the switch.
Apply Teflon tape to the thread on the flow switch and screw the flow switch into the pipe c
Apply Teflon tape to the thread on the flow switch and screw the flow switch into the pipe c
switch using the spanner flats on the body. Avoid tightening the switch via the electrical enc
switch using the spanner flats on the body. Avoid tightening the switch via the electrical en
damage the switch.
damage the switch.
Alignment of the switch is critical to correct operation. The switch should be in line with the
in the direction of flow.
Alignment of the switch is critical to correct operation. The switch should be in line with the
Alignment of the switch is critical to correct operation. The switch should be in line with the
Remove the lid on the electrical enclosure and insert the wires into the cable entry. Connec
in the direction of flow.
in the direction of flow.
terminals labelled "COMM" and "NO".
Remove the lid on the electrical enclosure and insert the wires into the cable entry. Connec
Remove the lid on the electrical enclosure and insert the wires into the cable entry. Connec
terminals labelled "COMM" and "NO".
terminals labelled "COMM" and "NO".
36