Hergom DEVA Instrucciones Para La Instalación, Uso Y Mantenimiento página 41

SEALING THE WORK SURFACE
Fig.4
Do not adjust the outer outline of the hob
to its fullest extent. Leave
movement (2-3 mm) so that when it
heats up i t can dilate (Figs. 2 and 5).
Changing the top smoke outlet for the rear outlet on DEVA II 100
and NANSA II models.
Fig.5
3 or 4 hours so as to allow it to dilate
a free
slowly. This will avoid breakages and
deformation, which could occur if these
instructions are not followed.
12
Do not narrow too much the
smoke passageway so as to
heat the hob in a uniform
manner (Figs. 4 and 5).
Use plaster or refractory clay
in order to adhere it to the
construction, and finish it off
inside by hand
accessible areas in order to
achieve total hermeticism.
When the cooker is lit for the
first time and a satisfactory
parts stabilisation is achieved:
Turn on the cooker gradually
and keep it on a low heat for
The cooker is supplied with
the smoke outlet ring installed
on the upper outlet. In order to
change the ring from the top to
the back outlet, release the four
screws that attach it to the hob,
remove the cover on the back
outlet and install the ring. Place
the ring on the back outlet and
the cover on the top outlet.
in the