Coupling Tool Stop During Processing (Blocked Pipe); Coupling Tool Stop During Processing - aquatechnik BBS 32 Instrucciones De Utilizacion

COUPLING TOOL STOP DURING PROCESSING

(BLOCKED PIPE)
If the Coupling tool BBS 32 stops during the working cycle, follow these simple steps:
1) unscrew the mechanical expander (G) (even by a
few revolutions only) in order to release the pipe
as illustrated in the picture beside;
bring the machine back into return position as
2)
indicated in chapter "Manual return of coupling tool
BBS 32;
check that the conical pin is lubricated. On the
3)
contrary, lubricate the conical pin with the suitable
grease (Item# 50825).
If the problem is not solved, send the Coupling tool BBS 32 to
for
aquatechnik
repairing.
COUPLING TOOL STOP DURING PROCESSING
In the event of machine block (the conical pin cannot
go forward or backward), see the following
instructions:
1) remove the tank cap (I) as illustrated in picture
11;
2) loosen the vent hole cap (L) by an
(3 mm) as illustrated in fig. 12;
3) press against the rubber tank in order to let air
go out of the vent hole. When air is completely
discharged and oil starts coming out (fig. 13),
close the vent hole cap (L) by the llen wrench;
4) replace the tank cap (I). Repeat these steps, if
needed.
If the problem is not solved, send the Coupling tool
BBS 32 to aquatechnik for eventual verification and repairing.
eventual verification
llen wrench
and
BBS 32
(patented)
Picture 9
Picture 10
Picture 11
Picture 12
Picture 13
ENGLISH 19