Installation; Notes On Safety For The Installation; Handling; Preliminary Checks - Riello RS 55/M BLU Instrucciones De Instalación, Uso Y Mantenimiento

5

Installation

5.1

Notes on safety for the installation

After carefully cleaning all around the area where the burner will
be installed, and arranging the correct lighting of the environ-
ment, proceed with the installation operations.
All the installation, maintenance and disassembly
operations must be carried out with the electricity
supply disconnected.
DANGER
5.2

Handling

The burner is delivered in cardboard packaging, so it is possible
to move the burner (still packaged) with a transpallet truck or fork
lift truck.
The handling operations for the burner can be
highly dangerous if not carried out with the great-
est attention: keep any unauthorised people at a
distance; check the integrity and suitableness of
WARNING
the available means of handling.
Check also that the area in which you are working
is empty and that there is an adequate escape
area (i.e. a free, safe area to which you can quick-
ly move if the burner should fall).
When handling, keep the load at not more than
20-25 cm from the ground.
5.3

Preliminary checks

Checking the consignment
After removing all the packaging, check the integ-
rity of the contents. In the event of doubt, do not
use the burner; contact the supplier.
CAUTION
The packaging elements (wooden cage or card-
board box, nails, clips, plastic bags, etc.) must not
be abandoned as they are potential sources of
danger and pollution; they should be collected and
disposed of in the appropriate places.
Checking the characteristics of the burner
Check the identification label of the burner, showing:
 the model (A)(Fig. 6) and type of burner (B);
 the year of manufacture, in cryptographic form (C);
 the serial number (D);
 the data for electrical supply and the protection level (E);
 the absorbed electrical power (F);
 the types of gas used and the relative supply pressures (G);
 the data of the burner's minimum and maximum output pos-
sibilities (H) (see Firing rate)
Warning. The burner output must be within the boiler's firing
rate;
 the category of the appliance/countries of destination (I).
20040559
Installation
The installation of the burner must be carried out
by qualified personnel, as indicated in this manual
and in compliance with the standards and regula-
tions of the laws in force.
WARNING
Combustion air inside the boiler must be free from
hazardous mixes (e.g.: chloride, fluoride, halo-
gen); if present, it is highly recommended to carry
out cleaning and maintenance more frequently.
DANGER
After positioning the burner near the installation
point, correctly dispose of all residual packaging,
separating the various types of material.
Before proceeding with the installation operations,
carefully clean all around the area where the burn-
er will be installed.
CAUTION
R.B.L.
D
X
GAS−KAASU
GAZ−AEPIO
S8375
A burner label, or any other component, that has
been tampered with, removed or is missing, pre-
vents the definite identification of the burner and
makes any installation or maintenance work diffi-
WARNING
cult.
12 GB
A B
E
G
G
G
I
C
F
H
H
H
Fig. 6