User Keypad Operation - Kohler K-1360 Guía De Propietario

Rotate outer ring to
access desired mode.
Power On/Off
Chromatherapy-Specific Color
(H2 models only)

User Keypad Operation

NOTE: Symbols illuminated in blue indicate available modes/features. Active modes will be illuminated
in green.
Power On/Off - The whirlpool pump turns on and off using the power button.
Heater - The heater automatically engages when the whirlpool is turned on. To turn the heater off,
rotate the outer ring until the heater mode is flashing and press "OK." Press "OK" again to turn the
heater back on. The heater will help to maintain the water temperature up to 104°F (40°C).
Outer Ring - Rotate the outer ring to the desired mode. The selected mode will flash (blue).
Activate Button - Press "OK" to activate the desired mode.
Flexjet Mode - When active, this mode allows you to adjust the water flow to the eight Flexjets by
pressing the up or down arrows.
Chromatherapy Cycle (H2 Models Only) - Chromatherapy lights will automatically and
continuously cycle through the eight colors: white, violet, indigo blue, aqua blue, green, yellow,
orange, and red. One cycle through all eight colors takes approximately one minute.
Chromatherapy Specific Color Selection (H2 Models Only) - When this mode is selected, you may
choose a specific color for the bath.
Indicator Bar - The indicator bar displays the water flow volume in the Flexjet mode. The pulse
speed is displayed in the neckjet or backjet mode.
Up Arrow - Increase the water flow by pressing the up arrow when the Flexjet mode is active.
Increase the pulse speed by pressing the up arrow when the neckjet or backjet mode is active.
Down Arrow - Decrease the water flow by pressing the down arrow when the Flexjet mode is
active. Decrease the pulse speed by pressing the down arrow when the neckjet or backjet mode is
active.
Waterfall Mode - When active, a continuous stream of water flows behind your neck. You may
adjust the flow volume by pressing the up or down arrows.
Whitewater Mode - When active, the two outside Riverjets behind your neck will operate, and you
may adjust the flow volume by pressing the up or down arrows.
Rapids Mode - When active, all four Riverjets behind your neck will operate, and you may adjust
the flow volume by pressing the up or down arrows.
Tidepool - This feature turns off the air flow to the jets for a soothing, relaxing effect. The Tidepool
feature may be used at any time while any of the jets are operating. The Tidepool mode does not
affect the Waterfall.
Kohler Co.
Flexjet Flow Mode
Activates Mode
Selected
Waterfall
Mode
Lighted User Keypad
Riverjet Whitewater Mode
Increases Flow
Riverjet Rapids Mode
Indicator Bar - Shows
water flow volume
Tidepool
Decreases Flow
Chromatherapy Cycle
(H2 models only)
Heater
5 1022211-5-D