Fill Your Whirlpool; Operating Your Whirlpool - Kohler K-1360 Guía De Propietario

Riverjet
Flexjet - Turn the jet trim ring fully
counterclockwise and position the jet
nozzles downward.

Fill Your Whirlpool

NOTE: Please read these steps carefully before operating your whirlpool.
NOTE: The water temperature in the whirlpool should not exceed 104°F (40°C). The heater will
automatically turn off as the water temperature approaches 104°F (40°C) and will remain off until the
water cools.
Turn the jet trim fully counterclockwise. Position the jet nozzles so they face down toward the basin.
NOTE: For Waterfall only use (no Flexjets or Riverjets), you only need to fill the bath to a level about 2"
(5.1 cm) above the top of the suction covers.
NOTE: For Waterfall or Flexjet use (no Riverjets), you only need to fill the bath to a level about 2" (5.1 cm)
above the top of the highest Flexjet.
To operate all the features: Fill the whirlpool to a level above the water-level sensors on either side
of the Riverjets.
NOTE: The Riverjets will only operate if both water-level sensors are completely covered with water. If the
water level drops below the sensors, the Riverjets will automatically turn off, and the Flexjets will turn on.
The Riverjets and Flexjets will not operate at the same time.

Operating Your Whirlpool

NOTE: A built-in heater automatically helps to maintain the water temperature when the whirlpool is
running, as long as the water temperature does not exceed 104°F (40°C). The heater will automatically
disengage at higher temperatures.
To turn the whirlpool on: Press the Power On/Off button or rotate the outer ring to access a
desired mode, as described below.
To access a desired mode: Rotate the outer ring until the icon is flashing blue. Press "OK" to
activate the mode. The active mode will flash green. To turn off a mode, rotate the outer ring until
the button is flashing green and press "OK" again. The icon will turn blue indicating the mode is
off.
Waterfall: When activated, the Waterfall will start to flow at medium volume within several
seconds. The Waterfall mode is not heated. Increase or decrease the water flow by pressing either
the up or down arrow buttons on the keypad. An indicator bar in the center of the keypad shows
the water flow volume. The Waterfall may be used alone, or with any one of the following: Flexjets,
or Riverjets in either the Whitewater mode or Rapids mode.
1022211-5-D
Water-Level Sensors - To use all functions,
fill to a level above both water-level sensors.
To use only the Waterfall and Flexjets, fill
to a level 2" (5 cm) over the highest jet.
Suction Cover
6
To use only the Waterfall, fill to a level
2" (5 cm) over the suction cover.
Kohler Co.