Idiomas disponibles
Idiomas disponibles
Mounting Dimensions
L Left Hand (LH) shown throughout instructions. Right Hand (RH) opposite.
Center Line of
Hinge/Pivot
A
1
Determine the degree of door opening required and find
dimensions "A" and "B" on the chart below.
A
Opening
To 120°
Closer
120° to 180°
B
Opening
To 120°
Shoe
120° to 180°
2
Measure from center line of hinge/pivot and stick
template on door. Mark drilling holes.
L See Mounting Dimensions above as needed.
Center Line of
Hinge/Pivot
Door
A
3
Remove template, and drill holes where marked with a
1/8" drill bit for SRT screws.
L SRT screws are used on metal doors.
Wood screws are used on wood doors.
4
Measure and determine your door's width. Using a hex
wrench, adjust the closer spring power. Use the table
below to determine number of turns required.
Turn counterclockwise for "-"; turn clockwise for "+"
L These turns are recommended, but may change due to
door weight and environmental conditions.
Door Width
Number of Turns
ADA Setting
32" - 815 mm
36" - 915 mm
42" - 1050 mm
48" - 1220 mm
54" - 1372mm
5
Install closer onto door.
L Speed regulation valve goes away from the hinge.
12"
Measurement from Door Edge
3 3/4"
1 1/4"
Measurement from Door Edge
9 3/8"
6 7/8"
Center Line of
Hinge/Pivot
Top Door Edge
B
Frame
Separate Before Using
−
-5
-3
0
+5
+10
+15
EDA
Frame
Center Line of
Hinge/Pivot
Door
3Z\,"
C\v"
Frame
View from floor
6
Install EDA shoe & fifth hole spacer onto frame.
L Use the fifth hole spacer only if there is a space between
the frame and the shoe.
L Intallation limited to reveals greater than 2 ZZ\zn".
Optional Fifth
hole spacer
7
Rotate closer shaft 45°, attach main arm with provided
1450 Series
fastener.
P.A. Mount - EDA Arm
© Allegion 2015
Printed in U.S.A.
71936 Rev.01/15-a
45º
Bottom Frame Lip Edge
Separate Before Using
8
Adjust the closer, if necessary. See page 3 for closer
adjustment instructions.
9
Screw cap onto shaft, or install cover.
L Use screws for full plastic and metal covers.
+
2
1"
2Z\zn"
C\,"
2"
B
2C\v"
M\zn"
Z\x"
