Brita PURITY 450 Steam Manual página 26

1 x Pressure Vessel
1 x Pressure Vessel Lid
1 x Filter Cartridge
1 x Manual
1 x Carbonate Hardness Test
1 x Sticker for Service Pass (orange)
1 x Adapter 1"–3/4"
If parts of the delivery scope are missing, please contact your local BRITA office (see the back of the
cover).
4.2 Assembling the Pressure Vessel and the Pressure Vessel Lid
4.3 Assembly of Inlet and Outlet Hoses
Note: The inlet and outlet hoses are not included in the standard scope of delivery. The use of
BRITA hose sets is recommended (Chapter 13).
•
Fit inlet hose
nector head
Note: Inlet "IN" and outlet "OUT" of the connector head
EN
seals, therefore no additional flat seals may be used here. Check that the O-rings are seated
correctly.
Caution: The max. tightening torque at the 1" and 3/4" connections must not exceed 15 Nm!
!
Only hose connections with flat seals may be used. Hoses with conical screwed connections dam-
age the filter head connections and invalidate any guarantee claims. Only hoses that comply with
DVGW-W 543 may be used to connect the device.
Before assembly, note the direction of flow on the upper side of the filter head, "IN" = water inlet,
"OUT" = water outlet. Prior to installation, note installation dimensions and operating position
(Chapter 12). If no original hoses are used, the 1"–3/4"
the return valve is sealed correctly (pre-fitted in the water inlet).
5 Commissioning a New Filter
5.1 Bypass Setting for Filter Systems without and with Measuring and Display Unit
• Identify the local carbonate hardness in German hardness °dH (BRITA nomenclature °KH) using
the enclosed carbonate hardness test.
• Check the bypass setting on the bypass screw
Note: The bypass has been set to Position 1 in the factory, and must be changed to suit the
local carbonate hardness and the application (Chapter 7).
22
1
3
2
•
Stand with both feet on the kick loops
•
Lift the pressure vessel
are over the kick loops
•
Remove the transport protective cap
•
Check that the O-ring seal of the filter cartridge
groove and also check for dirt and damage.
Note: lubricant at the factory.
•
Stand on the kick loops
on the pressure vessel
handle must match the "INSERT" groove.
20
•
Press the pressure vessel lid
engages.
at the inlet of the connector head
6
.
4
.
12
and turn it clockwise until the mantle handles
1
.
12
from the filter cartridge.
18
with both feet and place the pressure vessel lid
12
. The position of the arrow marking on the lid
1
down and turn clockwise until the lock
3
and outlet hose
4
are equipped with O-rings as
4
adapter supplied must be used to ensure
17
.
19
is correctly seated in the
2
at the outlet of the con-
10
16
3
15