COMFORT-AIRE RG Serie El Manual Del Propietario página 20

INSTALLATION INSTRUCTIONS
Bottom
Rail Seal
Fig.13
5 Install Support Bracket
1. Hold each support bracket flush against
outside of sill, and tight to bottom of cabinet
as shown in Fig.15A. Mark brackets at top level
of sill, and remove.
2. Assemble sill angle bracket to support
brackets at the marked position(Fig.15B).
Hand tighten, but allow for any changes later.
NOTE: Check that air conditioner is tilted back about
1 / to 1 / 1 5 (tilted about 3 t o 4 downward t o th e o utside).
4 8
After proper installation, condensate should not
drain from the overflow drain hole during normal use, correct
drain from the overflow drain hole during•• n • • r mal•• u se,••
the slope otherwise (Fig. 14).
correct•• the slope otherwise (Fig.14).
Window Sash
FIG.14
Measure from
the cabinet edge.
Sill Angle Bracket
Window Sill
Mark
Fig.15A
3 4 (or1 /2 )Long
Hex-head Screw
O O
About1 / to1 / 1 5
4 8 5
Side Louvers
Owner's Manual - RG/RADS Series
Left
Locknut
Sill Angle
Bracket
Flat Head
Bolt
2 Each Required For
Each Support Bracket
Fig.15B
3. Install support brackets(with sill angle
brackets attached) to correct hole in
bottom of cabinet as shown in Fig.16.
4. Tighten all 6 bolts securely.
Fig.16
Extend Window Filler Panels
6
1. Carefully raise window to expose filler panel
locking screws. Loosen screws so filler panels
slide easily.
2. Extend panels to fill window opening completely.
Tighten locking screws on top(Fig.17).
3. Close window behind top angle.
Fig.17
18
1 2 Long Screws
And Locknuts
Right
1 2 Long Screws
and Locknuts
7/16"Locking Screw
and Washer