Ingeteam
1. Control bar > Add device
2. In the pop-up window in Device Type , select the type of device to be added and
configure the settings.
3. Then select the settings associated to the devices.
4. Click on Find . If the unit is correctly connected and configured a warning is displayed
with the device's serial number and firmware.
5. Finally, save the settings by clicking on Save .
5.5 Re-starting the strategy
After adding and configuring all the devices in our installation and configuring the settings for
our strategy, the strategy is rebooted. Do this using Control bar > Control > Start control .
After a few seconds, our system starts to operate.
5.6 Production data
To download and view the production data from the installation, follow the steps below:
1. Access the installation from the INGECON SUN EMS Tools start screen.
2. Establish direct connection with the device Control bar > Connect.
3. Bring up the Data/Graphs tab in the user interface Control bar > View > Data/Graphs .
4. Select the desired day.
In addition to daily viewing, INGECON EMS Tools offers the possibility of viewing downloaded
logs by selecting a range of dates or by using the system's predefined ranges (daily, weekly,
monthly and annually).
The EMS energy manager stores the production data from the past 30 days. It is
necessary to download data during this period.
5.7 Configuration changes
To make changes in the installation, access it in installer mode following the steps given in the
section "Accessing to the installation in installer mode" and stop the control as indicated in the
section "Stopping the strategy in process" . Select the element to be changed and change the
required parameters from the Device Properties tab. After making the changes, click on Save .
5.8 Resetting the factory configuration
To restore the factory settings, click on the Reset Factory Configuration icon in the Device
Properties panel. Then, reboot the device Control bar > Reboot EMS.
AAX2026IQM05_B.docx
Configuration manual
51