Bosch CR 10 H Manual Del Usuario página 22

Operating the appliance
Description of the displays
Heat source producing heat.
Service display (maintenance required)
▶ Press the selector to switch to the standard display.
Fault display alternating between fault code and sub-code
( Troubleshooting)
▶ Press selector to briefly show the current room temperature.
Setting the desired room temperature
▶ Turn the selector to select the desired room temperature.
The setting is adopted automatically. It overrides the
corresponding setting in the higher-level user interface
– In automatic mode: until the next switching time in the
program
– In optimised mode: until the end of optimised mode
It is only possible to set the operating mode (automatic mode/
optimised mode) at the higher-level user interface.
Switching off the heating
▶ Reduce the desired room temperature, until OFF appears. When
the heating is switched off, frost protection for the room is also
switched off. Frost protection of the heat source remains active.
Switching display between heating and ventilation
Only in combination with heating:
▶ In order to switch between the display for the current room
temperature and the current ventilation level, press the selector
for longer than 3 seconds and then release.
22
CR 10 H – 6720876740 (2017/08)
Example
°C
°F
°C
°F
Result
°C
°F
°C
°F
Result
°C
°F
Result
°C
°F