Groups; How To Configure A Group - Nice MG3000 Manual Completo

Door sensor delay
Schedule bell delay
Clock calibration
Dry finger
Remove finger 2nd
If the receiver or scanner is not present or does not respond to the reading re-
quest sent by the MG3000, after 3 seconds the module will return the message
"NO ANSWER".

11.11 GROUPS

NOTE: The use of "GROUPS" is only valid when the MG3000 is used with
RMF3004 receivers or 4A Multifunction Receivers.
Through the option "GROUPS" it is possible to select user groups and define
dates and times for each group to have access granted.
This configuration can be useful for controlling the access of employees or ser-
vice providers who do not have free access to the building, increasing security
and preventing users from having access outside the allowed days and times.

11.11.1 HOW TO CONFIGURE A GROUP

Access the option "GROUPS" and enter the identification name for group 1.
Then tap "RECORD" and tap "PROCEED".
82
Biometric Controller open door alarm
time in seconds [0 to 250]
Programmable alarm time in seconds
[0 to 15]
Time in seconds for clock offset [-60 to
+60]
Wet finger adjustment [0 to 8]
Awaits the finger removal from the sen-
sor
Figure 11.10.d
- ENGLISH -
285