Programmable Keys; Timed Keys - Nice MG3000 Manual Completo

11.3.1 PROGRAMMABLE KEYS

From the "PROGRAMMABLE KEYS" screen, select the arrows using the key
index to be configured. Each selected index automatically loads the functions
related to the type of receiver, its address and the output (relay) that will be ac-
tivated by pressing the respective button on the "CONTROLS" screen. Pressing
the index button allows you to test the activation.
Once the programmable keys have been configured, they can be activated either
by the "REMOTE ACTIVATION" screen or by the TERMINAL BLOCK MODULE
(optional). The activations performed by the MG3000 keys, or through the Termi-
nal Block Module, are registered and stored in the MG3000's internal memory.
NOTE: The Terminal Block Module must be connected via RS485 or Adapter
Interface (depending on the Terminal Block Module model), so that events are
recorded and so that the activation is done via the CAN network (without direct
physical connection with the door command).
* If not working, refer to the Key Timing function, 11.3.2. If the time is enabled, the
keys will only function after the activation of the triggering device (control, card,
Tag...) corresponding to the key's programming.

11.3.2 TIMED KEYS

The "TIMED KEYS" option allows you to enable the timing of the MG3000's keys,
from 1 to 99 seconds for release after triggering a device.
The timed key will take effect depending on the setting made in the "PRO-
GRAMMABLE KEYS" function.
56
Figure 11.3.1.a
- ENGLISH -
259