STEINEL L830 LED iHF Información página 18

The light source of this luminaire cannot be replaced. If the light source needs
to be replaced (e.g. at the end of its service life), the complete luminaire must
be replaced.
5. Mounting
• Check all components for damage.
• Do not use the product if it is damaged.
• When installing the sensor-switched light, make sure the installation site is
not exposed to vibration.
• Select an appropriate mounting location, taking the reach and motion
detection into consideration.
Mounting procedure (L 830 / L 835 / L 840 LED iHF)
• Switch OFF power supply. (Fig. 4.1)
• Undo retaining screws and detach light cube from the wall mount. (Fig. 5.1)
• Mark drill holes (Fig. 5.2)
• Drill holes and fit wall plugs. (Fig. 5.3)
• Pierce sealing plug.
• Installation with concealed power supply lead (Fig. 5.4)
• Installation with surface-mounted power supply lead (Fig. 5.5)
• Connect conductors (Fig. 5.6)
• Make settings ➔ "6. Function" (control dials only)
• Fit light cube onto wall mount (Fig. 5.7)
• Screw in retaining screws (Fig. 5.7)
• Switch ON power supply (Fig. 5.7)
Mounting procedure (GL 80 LED iHF)
• Switch OFF power supply (Fig. 4.1)
• Undo retaining screw and remove light cube from the cover (Fig. 5.8)
• Pull cable through base plate and profile (Fig. 5.9)
• Screw base plate to profile (Fig. 5.10)
• Mark base plate drill holes (Fig. 5.11)
• Drill holes and insert screw anchors (Fig. 5.12)
• Screw base plate to the floor/ground (Fig. 5.13)
• Screw cover onto profile (Fig. 5.14)
• Connect conductors (Fig. 5.15)
• Make settings ➔ "6. Function" (control dials only)
• Fit light cube to cover (Fig. 5.16)
• Screw in retaining screw (Fig. 5.16)
• Switch ON power supply (Fig. 5.16)
- 34 -
6. Function
Factory settings:
– Time setting: 5 seconds
– Reach setting: 5 m
– Twilight level: 2000 lux
– Night light: ON
Functions can be set via Smart Remote app or control dial.
Note:
The settings last selected on the control will be used.
Smart Remote app
To configure the light via smartphone or tablet, you must download the
STEINEL Smart Remote app from your app store. You will need a Blue-
tooth-capable smartphone or tablet.
Android
Additional functions only via the Smart Remote app:
– Main light / night light level can be adjusted
– Extended reach adjustment
– Group interconnection
– Twilight setting by teach-in
Control dials (Fig. 6.1)
Time setting (stay-ON time) (Fig. 6.2/D)
The light's ON time can be set to any period from approx. 5 seconds to a
maximum of 15 minutes. Any movement detected before this time elapses will
restart the timer.
iOS
- 35 -