BH FITNESS YH2000 Manual Del Usuario página 8

If you do not place both hands
correctly, as shown in Fig.3, the pulse
sensor will not work and if no pulse is
detected after 16 seconds then a "P
" (no heart beat) will appear on the
screen. Make sure that both hands are
placed on the sensors (R) and that
connector (Z) is connected at the back
of the electronic unit.
TROUBLESHOOTING GUIDE.-
Problem: The display comes on but
only the Time function works.
Solution:
a. Make sure that the connection cable
is connected.
Problem: The display does not come
on or the displayed segments are very
weak.
Solution:
a. Check that the batteries are fitted
correctly.
b. Check the battery charge
c. If they are run down change them
immediately.
Problem: Display segments of a
function read-out are not visible or
error messages
function appear.
Solution:
a. Remove
seconds and then refit them correctly.
b. Check the battery charge If they are
run down change the batteries
c. If the above steps do not help then
replace the electronic monitor.
Avoid leaving the electronic monitor in
direct sunlight as this might damage
the liquid crystal display. Similarly, do
not expose it to water or knocks.
In case of technical assistance, please
contact by telephone (see final page
of this manual)
THE MANUFACTURER RESERVES
THE RIGHT
SPECIFICATIONS
PRODUCTS
NOTICE.
8
for a
the batteries
TO MODIFY
OF
WITHOUT
particular
for 15
THE
ITS
PRIOR