Recharging The Battery; How To Connect Each Part - Dentsply Maillefer X-SMART DUAL Manual Del Usuario

B.

Recharging the battery

device
The is delivered with a rechargeable battery.
Procedure for recharging the battery:
1. Connect the AC cable to the charger
2. Connect the charger cable to the right side of unit
3. Connect the charger to the main power source
4. The AC/DC and the battery charge status symbols are indicated on the screen
5. The AC-IN lamp lights in green and the CHRG lamp lights in orange
6. When the CHRG lamp turns off, charging has been completed.
7. The AC/DC and the battery charge status symbols are indicated on the screen
Duration of charging: Depending of the battery charge level, up to 3 hours.
Note: The unit can be operated on battery or electrical power (while battery is charging) in
motor and dual modes. In apex locator mode, when using the apex locator accessory set,
the unit can only be operated on battery power.
C.

How to connect each part

1. Connect the motor handpiece or the measurement cable on the front of the unit:
Align the  mark of the cord plug with the  mark of the unit connector and
insert the plug until it locks.
NOTICE: To remove the plug, hold the plug ring and pull it down.
2. Connect the contra angle to the motor handpiece until it locks and check the
connection by gently pulling in the opposite direction.
NVG / F190294X / 06 / 2007 –updated 08/2009
LCD panel indications
Operation panel indications
- 9 / 148 -