Settings; Torque Calibration; Calibration Procedure - Dentsply Maillefer X-SMART DUAL Manual Del Usuario

H.

Settings

This product is programmed in advance with 1 to 9 programs according to various files to
be used. You can change any preset values and have them saved to your desired settings
(operating mode, rotation speed, torque limit value, auto reverse mode).
1. Press the PROGRAM key until it turns to the program number which you want to
memorize.
2. Adjust the values or modes by each key according to your needs.
3. Hold down the MEMO key button for more than 1.5 seconds to save settings.
I.

Torque calibration

This function is used to decrease fluctuation in the rotation speed of the motor handpiece
and the difference in torque by the contra angle.
The motor handpiece calibration is recommended when using a new contra angle or after
an extended period of operation, as the running properties can change with usage,
cleaning and sterilization.

Calibration procedure:

Lubricate the contra angle with the X-SMART
1.
2. Attach the contra angle head to the motor handpiece.
3. Connect the AC adapter if the battery capacity remaining is 25% or less.
4. Turn on the power.
5. Hold down both buttons of the SPEED simultaneously for more than one second.
6. The calibration starts and LCD panel display indicates :
7. The motor handpiece begins to rotate : leave it as it is until it stops.
8. This process ends, if the rotation stops and the LCD panel display returns to its
original state.
NOTICE: Do not touch or apply a load to the rotating shaft of the contra angle
NVG / F190294X / 06 / 2007 –updated 08/2009
The calibration procedure runs automatically.
The torque of the non-loaded contra angle is
measured at six different speeds.
The procedure is completed once the counter has
counted back to "00" in the "TORQUE" field.
head : it obstructs.
TM
spray.
- 16 / 148 -