V2 FORTECO 2500-I Manual Del Usuario página 62

Brake Function
When a sliding motor is used with a very heavy gate, because of the
inertia, the gate does not block immediately when stopped and its
motion can last for another 10 cm, compromising the working of the
safety devices.
This menu allows enabling the brake function thanks to which it is
possible to block immediately the gate after a control or the intervention
of a safety device.
0 the brake function is never active
1 ÷ 10 the brake function is active. Le brake power is proportional to
the set value
Following to an intervention of the safety edge or of the obstacle sensor
or of a STOP control, the braking has always the maximum power,
regardless of the set value (provided that higher than 0) to guarantee a
rapid reversion.
WARNING: each braking entails a mechanical stress to the components
of the motor. We suggest to set the minimum value with which there is
a satisfactory stop distance.
Enabling the AMPEROMETRIC obstacle sensor
This menu allows to adjust of the sensitivity of the AMPEROMETRIC
obstacle sensor.
When the power absorbed by the motor exceeds the level set,
an alarm goes off in the power unit.
If 0.0A is set, the function is disabled.
Refer to Chapter 10 for sensor operation
Enabling the SPEED obstacle sensor
This menu allows to adjust the sensitivity of the SPEED obstacle sensor.
When motor speed drops below the set value, the control unit raises an
alarm.
The value shown is in cm/s
Refer to Chapter 10 for sensor operation
Slow down in opening
This menu allows regulating the percentage of the ride/drive that is
carried out at reduced speed during the last opening stretch.
60