V2 FORTECO 2500-I Manual Del Usuario página 65

t.LUC the relay is enabled at the receiving of a control of start or pedestrian start; choosing this option, a submenu is entered - it allows
to set the length of the activation of the relay from 0.0" to 20'0 (default 1'00). At the time limit, the relay is disabled.
no the relay of the courtesy lights is not automatically activated
CiCL the relay is activated during the motion of the gate; when the gate stops (closed or open) the relay is on all the time t.LUC long
(set in the submenu t.LUC).
If the option LP.PA is activated, the relay is on also during the pause time
Courtesy lights
This menu allows setting the automatic operating
of the courtesy lights during the opening cycle of
the gate.
NOTE: If the output is used to drive a flashing
light (with internal flasher) select CiCL.
Auxiliary channel
This menu allows setting the operating of the relay of the lighting of the
courtesy lights by means of a remote control stored on the channel 4 of
the receiver.
tiM the relay is activated receiving the transmission of the remote
control; it is disabled after the time set for the parameter
t.LUC inside the menu LUCi
biSt the status of the relay changes at each transmission of
the remote control
Mon the relay is activated for all the length of the transmission of
the remote control. Releasing the key of the remote control the
relay is deactivated
Blinker during pause time
Blinker usually operates during the gate motion only; however, if this
function is enabled, blinker will be on during the pause time too
(gate open with automatic closure active).
63