Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Maintenance of the belt
With the machine turned off and the cardan
uncoupled, check the belt deflection each 50
working hours or weekly, pressing it with the thumb,
throught the hole (1) of the rear shield (2).
Recommended play
1,0 to 2,0 cm
Belt tensioning
a) Loosen the four bolts (3), using a wrench and
turn the nut (4) clockwise.
b) Then, after adjusting the proper tension re-
tighten the bolts (3).
Note:
Check the general conditions of the belt and in case it presents excessive wear
and/or shredding, replace it.
Besides, that, keep it always clean and free from grease and oil, because such
products are harmful to the belts, causing premature deterioration.
22
x max = 2cm
Operation Technical Manual
11
12
Belt scheme play
1
2
3
4
Capítulos
Tabla de contenido
